[Contents] [Prev] [Next] [Index] [Report an Error]

J-Web Configuration

To configure the loopback interface on the VPLS PE router:

  1. Select Configuration>View and Edit>Edit Configuration.

    The Configuration page appears.

  2. Select Interfaces.
  3. In the Interface name column, select lo0.
  4. Under Unit, in the Interface unit number column, click 0.
  5. In the Family group, select Inet and click Edit.
  6. Next to Address, click Add new entry.
  7. In the Source box, type the address 127.0.0.1/32.
  8. Click OK to return to the Inet page.
  9. Next to Address, click Add new entry.
  10. In the Source box, type the address 10.255.7.168/32.
  11. Select Primary.
  12. Click OK to return to the Family page.
  13. In the Family group, select Iso and click Edit.
  14. Next to Address, click Add new entry.
  15. In the Source box, type the address 47.0005.80ff.f800.0000.0108.001.0102.5500.7168.00.
  16. Click OK to return to the Family page.
  17. In the Family group, select inet6 and click Edit.
  18. Next to Address, click Add new entry.
  19. In the Source box, type the address address abcd::10:255:7:168/128.
  20. Select Primary.
  21. Click OK to return to the Family page.
  22. Click OK to return to the Unit page.
  23. Click OK to return to the Interface page.
  24. Click OK to return to the Interfaces page.

To configure the interface to the PE2 router on the VPLS PE router:

  1. On the Interfaces page, select the interface to the PE2 router (so-2/0/1 in this example) from the Interface name column.
  2. Under Unit, in the Interface unit number column, click 0.
  3. In the Family group, select Inet and click Edit.
  4. Next to Address, click Add new entry.
  5. In the Source box, type the address 10.1.1.1/30.
  6. Click OK to return to the Unit page.
  7. On the Unit page, select Mpls in the Family group.
  8. Click OK to return to the Interfaces page.
[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.