[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring the ISDN Interface for Dialer Watch

To configure the ISDN interface to participate as a dialer watch interface:

  1. Navigate to the top of the interfaces configuration hierarchy in either the J-Web or CLI configuration editor.
  2. Perform the configuration tasks described in Table 59.
  3. If you are finished configuring the device, commit the configuration.
  4. Go on to any of the following optional tasks:
  5. To verify that the network interface is configured correctly, see Verifying the ISDN Configuration.

Table 59: Configuring an ISDN Interface for Dialer Watch

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Interfaces level in the configuration hierarchy, and select an ISDN physical interface—for example, br-1/0/3 for ISDN BRI.

For ISDN PRI, select a channelized T1/E1/ISDN PRI interface—for example, ct1-1/0/1.
  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to Interfaces, click Configure or Edit.
  3. Under Interface name:
    • For ISDN BRI, click br-1/0/3.
    • For ISDN PRI, click ct1-1/0/1.

From the [edit] hierarchy level:

  • For ISDN BRI, enter

    edit interfaces br-1/0/3 dialer-options pool isdn-dialer-group

  • For ISDN PRI, enter

    edit interfaces ct1-1/0/1 dialer-options isdn-dialer-group

Configure dialer watch options for each ISDN interface participating in the dialer watch feature.

Each ISDN interface must have the same pool identifier to participate in dialer watch. Therefore, the dialer pool name isdn-dialer-group, for the dialer watch interface configured in Table 58, is used when configuring the ISDN interface.

  1. Next to Dialer options, click Edit.
  2. Next to Pool, click Add new entry.
  3. In the Pool identifier box, type isdn-dialer-group.
  4. Click OK.
 
[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.