 |
Note: You can configure J-series devices with ADSL PIMs for connections through ADSL only, not for direct ATM connections. |
J-series devices with ADSL Annex A or Annex B PIMs can use an Asynchronous Transfer Mode (ATM) interface to send network traffic through a point-to-point connection to a DSL access multiplexer (DSLAM).
|
Note: You can configure J-series devices with ADSL PIMs for connections through ADSL only, not for direct ATM connections. |
To configure Point-to-Point Protocol (PPP), see the JUNOS Network Interfaces Configuration Guide.
You configure the underlying ADSL interface as an ATM interface, with an interface name of at-pim/0/port. (For information about interface names, see Network Interface Naming.) Multiple encapsulation types are supported on both the physical and logical ATM-over-ADSL interface.
This section contains the following topics:
 | Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |