Configuring and Monitoring Alarms

[Contents] [Prev] [Next] [Index] [Report an Error]

Alarms alert you to conditions on a network interface, on the device chassis, or in the system software that might prevent the device from operating normally. You can set the conditions that trigger alarms on an interface. Chassis and system alarm conditions are preset.

An active alarm lights the ALARM LED on the front panel of the device. You can monitor active alarms from the J-Web interface or the CLI.

This chapter contains the following topics. For more information about alarms, see the JUNOS System Basics Configuration Guide.

Alarm Terms
Alarm Overview
Before You Begin
Configuring Alarms with a Configuration Editor
Checking Active Alarms
Verifying the Alarms Configuration

[Contents] [Prev] [Next] [Index] [Report an Error]