Installing a WXC ISM 200

You can install a single WXC ISM 200 in either regular or high-speed slots of a J2320, J2350, J4350, or J6350 Services Router. The module occupies two slots, and the extra connector on high-speed slots is detected and configured automatically. If you insert a second WXC ISM 200, the module in the higher slot numbers will not power on.

Caution: Do not hot-swap WXC Integrated Services Modules or PIMs. Failure to power off the router before removing or installing a module might result in damage to the hardware.

To install a WXC ISM 200 (see Figure 5):

Figure 5: Installing a WXC Integrated Services Module

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the Services Router is disconnected from earth ground. For more information about ESD, see the J-series Services Routers Hardware Guide.
2. Back up the current router configuration.
3. To power off the router, use the CLI command request system power-off (recommended), or hold down the power button for at least 2 seconds. Verify that the POWER LED blinks and then turns off.
4. Remove the faceplates from two of the slots.
5. Align the notches in the connector at the rear of the WXC ISM 200 with the notches in the Services Router slot, and slide the module in until it lodges firmly in the router.

   Caution: Slide the WXC ISM 200 straight into the slot to avoid damaging the components on the module.

6. Tighten the screws on each side of the module faceplate.
7. Press and release the power button to power on the router. Verify that the POWER LED for the J-series Services Router lights steadily after you press the power button.
8. Verify that the ONLINE LED on the module lights steadily green.

   You can also verify the module is online by issuing the show chassis fpc pic-status command:

   
   user@host> show chassis fpc pic-status

   Slot 0	Online	FPC
     PIC 0	Online	4x GE Base PIC
   Slot 2	Online	FPC
     PIC 0	Online	Integrated Services Module

   Note: In show chassis fpc-pic-status output, the higher of the two slot numbers occupied by the WXC ISM 200 is reported as an FPC number, and the PIC number is always zero.

   For more information about show chassis fpc pic-status, see the JUNOS System Basics and Services Command Reference.

9. Complete the initial configuration of the WXC ISM 200, as described in Configuring a WXC Integrated Services Module.

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.