To establish basic connectivity on a Services Router, you must identify the router, connect the router to the network, and specify basic network settings. This section explains how to use the command line interface (CLI) configuration wizard for JUNOS software to configure basic settings so that you can connect the router to a network and further configure it using the J-Web interface or the CLI.
 |
Note: To use the CLI configuration wizard, you must have JUNOS software installed on your Services Router. If JUNOS software is not installed on your Services Router, following the instructions inConfiguring Basic Settings with J-Web Quick Configuration to use the J-Web Quick Configuration pages to configure basic settings or use the CLI, as described in Configuring Basic Settings with a Configuration Editor. |
 | Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |