[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
System Requirements for Dual PIM Multicast VPNs: Draft Rosen
- JUNOS Release 8.2 or later for support on MX-series routing
platforms.
- JUNOS Release 7.2 or later for MSDP in a Layer 3
VPN.
- JUNOS Release 7.1 or later for multicast distribution
trees for data.
- JUNOS Release 6.4 or later for PIM sparse mode graceful
restart and configuring a PE router as the VPN C-RP.
- JUNOS Release 5.5 or later for PIM dense mode and logical
loopback interfaces.
- JUNOS Release 5.3 or later for PIM sparse mode.
- Any hardware needed in your network to enable your Juniper
Networks routers to act as PE routers.
- On M-series and T-series routers, a Tunnel Services PIC
or for any provider core router acting as an SP-RP.
- On M-series and T-series routers, a Tunnel Services PIC
for any PE router where GRE tunneling is needed.
- On M-series and T-series routers, a Tunnel Services PIC
for any CE or PE router acting as a DR or VPN C-RP.
- On M-series and T-series routers, a Tunnel Services PIC
is required for GRE tunneling, as specified in Section Two of the
IETF Internet draft Multicast in MPLS/BGP
VPNs.
- For point-to-multipoint TE, a Tunnel Services PIC or vrf-tabel-label
configuration.
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]