AIM General Settings Commands and Parameters

Table 11 describes the General Settings page command button.

Table 11: General Settings Command Button

Button Name	Description	Privileges	Enabled/ Disabled	Results
Save Settings	Saves any modified AIM general settings and updates the AIM service with these new settings.	AIM Admin Settings	Enabled if admin privileges	Saves settings that were modified.

Table 12 describes the AIM General Settings parameters.

Table 12: General Settings Parameters

Name	Description	Privileges	Range/ Length	Default
Incident Scan Interval (min):	Interval used to scan for new incidents in AIM archive locations.	AIM Admin Settings	0 = Off, 1 - 1440 (60 seconds - 24 hours)	3 minutes
Case Status Update Interval (min)	Interval used to poll for JTAC Case status updates from Juniper Support Systems Case Manager	AIM Admin Settings	1 - 1440 minutes (60 seconds - 24 hours)	4 minutes
Intelligence Update Scan Interval (min)	Interval used to poll for intelligence updates for this site in AIM archive locations.	AIM Admin Settings	1 - 1440 minutes (60 seconds - 24 hours)	3 minutes
Information JMB Config Filter Level	Specifies the amount of device configuration information in Juniper Message Bundles to share with Juniper: Do not send Send all information except configuration Send all information with IP Addresses overwritten Send all information	AIM Admin Settings	N/A	Do not send
Upload Information JMB Interval	Interval used to send any newly detected Intelligence JMBs to Juniper Support Systems: On Detection Daily Weekly Monthly	AIM Admin Settings	N/A	Monthly
Local RMI Port	Port on which the AIM Service listens for requests from the client	AIM Admin Settings	1-65535	1022