Configuring AIM General Settings > Configuring General Settings

AIM General Settings allow the user to do the following:

• Set the interval used by AIM to scan device archive locations for Juniper Message Bundles (JMBs).
• Set the interval used by AIM to poll Juniper Support Systems for case status updates.
• Set the interval used by AIM to poll Juniper Support Systems for intelligence updates specific to the customer
• Set the amount of information sharing included in informational JMBs
• Set the interval used to send newly detected information JMBs to JSS
• Set the port on which the AIM Service listens for requests from the client. The default port number is the value set during the AIM installation.

To configure AIM General settings, follow these steps:

1. Click the Settings Tab. The General Settings page appears.
2. Add the required AIM General settings. See Table 11 and Table 12.
3. Click Save Settings. This action saves the AIM General settings that you modify and updates the AIM service with these new settings.