Step 4: Display Extensive Status Information for a Channelized OC-12 IQ Interface
Action
To display extensive status information for a Channelized OC-12 IQ interface, use the following JUNOS CLI operational mode command:
user@host>show interfacesinterface-type-interface-nameextensiveSample Output 1
The following sample output is for a controller interface:
user@host>show interfaces coc12-0/0/0 extensivePhysical interface: coc12-0/0/0, Enabled, Physical link is UpInterface index: 138, SNMP ifIndex: 82, Generation: 21Link-level type: Controller, Clocking: Internal, SONET mode, Speed: OC12,Loopback: None, Parent: NoneDevice flags : Present RunningInterface flags: Point-To-Point SNMP-TrapsLink flags : NoneHold-times : Up 0 ms, Down 0 msCoS queues : 4 supportedLast flapped : 2004-05-18 21:25:45 UTC (2d 00:04 ago)Statistics last cleared: NeverSONET alarms : NoneSONET defects : NoneSONET PHY: Seconds Count StatePLL Lock 0 0 OKPHY Light 0 0 OKSONET section:BIP-B1 0 0SEF 77 1 OKLOS 77 1 OKLOF 77 1 OKES-S 77SES-S 77SEFS-S 77SONET line:BIP-B2 0 0REI-L 82584 1274876RDI-L 5 1 OKAIS-L 0 0 OKBERR-SF 77 1 OKBERR-SD 2 1 OKES-L 77SES-L 77UAS-L 67ES-LFE 82589SES-LFE 5UAS-LFE 0Received SONET overhead:F1 : 0x00, J0 : 0x00, K1 : 0x00, K2 : 0x00S1 : 0x00Transmitted SONET overhead:F1 : 0x00, J0 : 0x01, K1 : 0x00, K2 : 0x00S1 : 0x00Sample Output 2
The following sample output is for a channel on a Channelized OC-12 IQ interface:
user@host>show interfaces t1-0/0/0:2:1 extensivePhysical interface: t1-0/0/0:2:1, Enabled, Physical link is UpInterface index: 186, SNMP ifIndex: 133, Generation: 69Link-level type: PPP, MTU: 1504, Clocking: Internal, Speed: T1,Loopback: None, FCS: 16, Framing: ESF,Parent: coc1-0/0/0:2 Interface index 185Device flags : Present RunningInterface flags: Point-To-Point SNMP-TrapsLink flags : KeepalivesHold-times : Up 0 ms, Down 0 msKeepalive settings: Interval 10 seconds, Up-count 1, Down-count 3Keepalive statistics:Input : 444 (last seen 00:00:05 ago)Output: 442 (last sent 00:00:09 ago)LCP state: OpenedNCP state: inet: Opened, inet6: Not-configured, iso: Not-configured, mpls:Not-configuredCHAP state: Not-configuredCoS queues : 4 supportedLast flapped : NeverStatistics last cleared: NeverTraffic statistics:Input bytes : 10948 0 bpsOutput bytes : 11792 0 bpsInput packets: 892 0 ppsOutput packets: 940 0 ppsInput errors:Errors: 2, Drops: 0, Framing errors: 0, Runts: 0, Giants: 0,Policed discards: 2, L3 incompletes: 0, L2 channel errors: 0,L2 mismatch timeouts: 0, HS link CRC errors: 0, SRAM errors: 0Output errors:Carrier transitions: 1, Errors: 0, Drops: 0, Aged packets: 0Queue counters: Queued packets Transmitted packets Dropped packets0 best-effort 3 3 01 expedited-fo 0 0 02 assured-forw 0 0 03 network-cont 937 937 0DS1 alarms : NoneDS1 defects : NoneT1 media:Seconds Count StateSEF 1 1 OKBEE 2 2 OKAIS 0 0 OKLOF 108 1 OKLOS 0 0 OKYELLOW 0 0 OKBPV 0 0EXZ 0 0LCV 1 1PCV 0 0CS 0 0LES 108ES 108SES 108SEFS 108BES 0UAS 116HDLC configuration:Policing bucket: DisabledShaping bucket : DisabledGiant threshold: 1514, Runt threshold: 0Timeslots : All activeLine encoding: B8ZS, Byte encoding: Nx64KBuildout : 0 to 132 feetData inversion: Disabled, Idle cycle flag: flags, Start end flag: sharedDS1 BERT configuration:BERT time period: 10 seconds, Elapsed: 0 secondsInduced Error rate: 10e-0, Algorithm: 2^15 - 1, O.151, Pseudorandom (9)SONET alarms : NoneSONET defects : NoneSONET vt:BIP-BIP2 0 0REI-V 25 25LOP-V 93 1 OKAIS-V 0 0 OKRDI-V 0 0 OKUNEQ-V 0 0 OKPLM-V 93 1 OKES-V 93SES-V 93UAS-V 83ES-VFE 25SES-VFE 25UAS-VFE 0Received SONET overhead:V5 : 0x02, V5(cmp) : 0x02Transmitted SONET overhead:V5 : 0x02Packet Forwarding Engine configuration:Destination slot: 0, PLP byte: 4 (0x00)Logical interface t1-0/0/0:2:1.0 (Index 70) (SNMP ifIndex 134)(Generation 15)Flags: Point-To-Point SNMP-Traps Encapsulation: PPPProtocol inet, MTU: 1500, Generation: 24, Route table: 0Flags: NoneAddresses, Flags: Is-Preferred Is-PrimaryDestination: 20.20.20.4/30, Local: 20.20.20.5, Broadcast: 20.20.20.7,Generation: 29What It Means
The sample output shows where the errors might be occurring: either with the channel media or the SONET layer. In this example, there are no errors. However, if errors occur, you must troubleshoot the channel media or the SONET layer. For more information, see the sections of this guide that correspond to the media with which you are working.