 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |
This chapter describes messages with the JCS prefix. They are generated by the Juniper Control System (jcsd) process.
Blade slot load BBD falure: error-message
The JCS process (jcsd) could not load blade bay data for the specified blade.
Error: An error occurred
error
Blade slot BBD error-message mismatch (expected-value != received-value)
The blade bay data retrieved for the specified blade does not match the data loaded during the reboot process. This error usually indicates that blade bay data in the JCS Management Module was changed since the last reboot.
Error: An error occurred
error
Blade slot bay data not found
Blade bay data was not found for the specified blade.
Error: An error occurred
error
Blade slot BBD is invalid
The blade bay data for the specified blade is invalid.
Error: An error occurred
error
Blade slot bay data parse error - error-message
The blade bay data for the specified blade did not parse correctly.
Error: An error occurred
error
Peer blade slot BBD error-message mismatch (expected-value != received-value)
The blade bay data retrieved for the specified peer blade does not match the data retrieved for the local blade. This error indicates that blade bay data in the JCS Management Module was not configured properly.
Error: An error occurred
error
Local BBD error-message (value) conflicts with blade slot
The blade bay data retrieved for the local blade conflicts with another blade in the JCS. This error indicates that blade bay data in the JCS Management Module was not configured properly.
Error: An error occurred
error
Switch slot EXT link state is state
The JCS process (jcsd) detects a change of state for the external link of the indicated switch module.
Event: This message reports an event, not an error
info
Invalid bandwidth percent (value)
The specified switch bandwidth is invalid. The bandwidth is defined as a percentage between 1 and 100.
Error: An error occurred
error
Kernel RSD link is DOWN (error-message)
The JCS process (jcsd) has disabled kernel RSD communcation for the specified reason.
Error: An error occurred
error
Kernel RSD link is ENABLED (error-message)
The JCS process (jcsd) has verified the blade bay data and enabled kernel RSD communication.
Event: This message reports an event, not an error
info
MM communication error (error-message)
The JCS process (jcsd) could not send an SNMP request to the Management Module because of the indicated error.
Error: An error occurred
error
MM communication is OK
The JCS process (jcsd) has established a communication link with the Management Module.
Event: This message reports an event, not an error
info
Peer blade slot is state
The JCS process (jcsd) detects a change of state for the indicated blade.
Event: This message reports an event, not an error
info
Read bandwidth error (error-code)
The indicated error occured when attempting to read the current switch bandwidth.
Error: An error occurred
error
Read blade bay data (error=error-code)
The indicated error occured when attempting to read the current blade bay data via a sysctl call.
Error: An error occurred
error
Switch slot RSD link state is state
The JCS process (jcsd) detects a change of state for the RSD link of the indicated switch module.
Event: This message reports an event, not an error
info
Switch slot bandwidth value1 percent (value2 KBPS)
The indicated JCS Switch Module has changed the bandwidth configuration to the specified value.
Event: This message reports an event, not an error
info
Switch slot communication error (error-message)
The JCS process (jcsd) could not send an SNMP request to the indicated Switch Module because of the indicated error.
Error: An error occurred
error
Switch slot communication is OK
The JCS process (jcsd) has established a communication link with the indicated Switch Module.
Event: This message reports an event, not an error
info
| Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |