Configuring an ES Tunnel Interface Between a PE and CE Router

This example shows how to configure an ES tunnel interface between a PE router and a CE router in a Layer 3 VPN. The network topology used in this example is shown in Figure 32.

Figure 32: ES Tunnel Interface (IPSec Tunnel)

To configure this example, you perform the steps in the following sections:

• Configuring IPSec on Router PE1
• Configuring the Routing Instance Without the Encapsulating Interface
• Configuring the Routing Instance with the Encapsulating Interface
• Configuring the ES Tunnel Interface on Router CE1
• Configuring IPSec on Router CE1

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.