Configuring Multilink and Link Services Logical Interface Properties

You configure multilink and link services interface properties at the logical unit level. Default settings for multilink and link services logical interface properties are described in the section Default Settings for Multilink and Link Services Logical Interfaces.

You can configure the following multilink and link services logical interface properties:

• Default Settings for Multilink and Link Services Logical Interfaces
• Configuring a Link Services Point-to-Point DLCI
• Configuring a Link Services Multicast-Capable DLCI
• Configuring a Drop Timeout Period
• Configuring Logical Interface Encapsulation
• Configuring a Fragmentation Threshold
• Configuring Link Services Delay-Sensitive Packet Interleaving
• Configuring Minimum Links
• Configuring the MRRU and MTU Values
• Configuring the Sequence Format
• Configuring Compressed RTP with MLPPP Encapsulation
• Configuring Compressed RTP with PPP Encapsulation

For general information about logical unit properties or family inet properties, see the JUNOS Network Interfaces Configuration Guide. For information about multilink and link services properties you configure at the family inet hierarchy level, see Configuring Bundles.

Note: On DS0, E1, or T1 interfaces in LSQ bundles, you can configure the bandwidth statement, but the routing platform does not use the bandwidth value if the interfaces are included in an MLPPP or MLFR bundle. The bandwidth is calculated internally according to the time slots, framing, and byte-encoding of the interface. For more information about these properties, see the JUNOS Network Interfaces Configuration Guide.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.