 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |
See the following sections:
- vpi vpi-identifier;
- [edit interfaces at-fpc/pic/port atm-options promiscuous-mode]
Statement introduced before JUNOS Release 7.4.
For ATM interfaces, allow all VCIs in this VPI to open in ATM CCC cell-relay mode.
When you include vpi statements at the [edit interfaces interface-name atm-options promiscuous-mode] hierarchy level, the specified VPIs open in promiscuous mode.
vpi-identifier—ATM virtual path identifier. This is one of the VPIs that you define in the vci statement. (For a list of hierarchy levels at which you can include the vci statement, see vci.)
See Configuring ATM Cell-Relay Promiscuous Mode.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
- vpi vpi-identifier {
-
maximum-vcs maximum-vcs;
-
-
oam-liveness {
- up-count cells;
- down-count cells;
- }
-
oam-period (disable | seconds);
-
-
shaping {
- (cbr rate | rtvbr peak rate sustained rate burst length | vbr peak rate sustained rate burst length);
-
queue-length number;
- }
- }
- [edit interfaces at-fpc/pic/port atm-options]
Statement introduced before JUNOS Release 7.4.
For ATM interfaces, configure the virtual path (VP).
vpi-identifier—ATM virtual path identifier. This is one of the VPIs that you define in the vci statement. (For a list of hierarchy levels at which you can include the vci statement, see vci.)
The remaining statements are explained separately.
See Configuring the Maximum Number of ATM1 VCs on a VP.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
multipoint-destination, promiscuous-mode, vci
- vpi virtual-path-identifier;
- [edit interfaces at-fpc/pic/port unit logical-unit-number],
- [edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number]
Statement introduced in JUNOS Release 9.0.
VPI used in an ATM-to-Ethernet interworking cross-connect.
virtual-path-identifier—VPI to be used.
See Configuring ATM-to-Ethernet Interworking and Configuring ATM Cell-Relay Promiscuous Mode.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
| Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |