 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |
See the following sections:
- transmit-weight (cells number | percent number);
- [edit interfaces interface-name atm-options
scheduler-maps map-name forwarding-class class-name]
Statement introduced before JUNOS Release 7.4.
For ATM2 IQ interfaces only, assign a transmission weight to a forwarding class.
95 percent for queue 0, 5 percent for queue 3.
percent percent—Transmission weight of the forwarding class as a percentage of the total bandwidth.
cells number—Transmission weight of the forwarding class as a number of cells.
See Configuring ATM2 IQ VC Tunnel CoS Components.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
- transmit-weight number;
- [edit interfaces interface-name unit logical-unit-number],
- [edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number]
Statement introduced before JUNOS Release 7.4.
For ATM2 IQ PICs only, configure the transmission weight.
Each VC is serviced in weighted round robin (WRR) mode. When VCs have data to send, they send the number of cells equal to their weight before passing control to the next active VC. This allows proportional bandwidth sharing between multiple VCs within a rate-shaped VP tunnel. VP tunnels are not supported on multipoint interfaces.
number—Number of cells a VC sends before passing control to the next active VC within a VP tunnel.
See Configuring the ATM2 IQ Transmission Weight.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
| Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |