Defining the Encapsulation for Switching Cross-Connects

To configure Layer 2 or Layer 2.5 switching cross-connects, configure the CCC or TCC encapsulation on the routing platform that is acting as the switch (Router B in Figure 9).

Note: When you use CCC encapsulation, you can configure the ccc family only. Likewise, when you use TCC encapsulation, you can configure the tcc family only.

This section contains the following topics:

• Configuring PPP or Cisco HDLC Circuits
• Configuring ATM Circuits
• Configuring Frame Relay Circuits
• Configuring Ethernet CCC Circuits
• Configuring Ethernet VLAN Circuits

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.