Configuring T3 Interfaces

This chapter includes an overview of T3 interfaces and configuration information as follows:

• T3 Interfaces Overview
• Configuring T3 Physical Interface Properties
• Configuring T3 BERT Properties
• Disabling T3 C-Bit Parity Mode
• Configuring the T3 CSU Compatibility Mode
• Configuring the T3 Frame Checksum
• Configuring the T3 FEAC Response
• Configuring the T3 Idle Cycle Flag
• Configuring the T3 Line Buildout
• Configuring the Channelized T3 Loop Timing
• Configuring T3 Loopback Capability
• Configuring T3 HDLC Payload Scrambling
• Configuring T3 Start and End Flags
• Examples: Configuring T3 Interfaces

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.