[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring ATM Mode on the PIM

The J-series Services Routers with an SHDSL PIM installed support the 2-port, two-wire mode (Annex A or Annex B). You can configure only one mode on each 2-port SHDSL PIM.

Note: G.SHDSL interfaces on a J-series Services Router only support 2-port, two-wire mode. This is enabled by default. The 1-port, 4-wire mode is not supported.

The two-wire mode supports autodetection of the line rate or fixed line rate and network speeds from 192 Kbps to 2.3 Kbps in 64-Kbps increments.

For information about configuring Annex A or Annex B, see Configuring SHDSL Operating Mode on an ATM Physical Interface.

To configure the ATM mode for SHDSL, include the pic-mode statement at the [edit chassis fpc fpc-number pic 0 shdsl] hierarchy level:



[edit chassis]
fpc fpc-number {


pic 0 {


shdsl {
pic-mode 2-port-atm);
}


}


}

The default is 2-wire mode. If nothing is configured, the SHDSL interface will be configured in 2-wire mode (2-port-atm).

For more information about configuring the pic-mode statement, see the JUNOS System Basics Configuration Guide. For information about configuring the ATM mode, see the J-series Services Router Basic LAN and WAN Access Configuration Guide.

[Contents] [Prev] [Next] [Index] [Report an Error]