[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring a Point-to-Point Frame Relay Connection

To configure a point-to-point Frame Relay connection, include the dlci statement:




dlci dlci-identifier;

You can include this statement at the following hierarchy levels:

[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number]

The DLCI identifier is a value from 16 through 1022. Numbers 1 through 15 are reserved for future use. A point-to-point interface can have one DLCI.

Note: For information about Frame Relay DLCI limitations for channelized interfaces, see Data-Link Connection Identifiers on Channelized Interfaces.

You configure the routing platform to use DLCI sparse mode by including the sparse-dlcis statement at the [edit chassis fpc slot-number pic pic-number] hierarchy level. For more information about DLCI sparse mode, see the JUNOS System Basics Configuration Guide.

For more information about Frame Relay DLCIs, see Configuring a Point-to-Point Frame Relay Connection.

When you are configuring point-to-point connections, the MTU sizes on both sides of the connection must be the same.

[Contents] [Prev] [Next] [Index] [Report an Error]