Entering Multiuser Mode

When JUNOS-FIPS is booted into single-user mode, a reboot is necessary to enter multiuser mode for normal operation with all services fully functional. You cannot exit the single-user shell and allow the system to come up in multiuser mode. A reboot loads the IPSec kernel module necessary for Routing-Engine-to-Routing-Engine communications in a multiple Routing Engine configuration.

Hit [Enter] to boot immediately, or space bar for command prompt. Booting [kernel] in 1 second... 
Type '?' for a list of commands, 'help' for more detailed help. ok boot -s Copyright (c) 1996-2001, Juniper Networks, Inc. All rights reserved. Copyright (c) 1992-2001 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved. JUNOS 7.2I20050420_0432_sjg #3: 2005-04-20 04:32:35 UTC
    sjg@swift.juniper.net:/c/sjg/work/7.2R1/obj-i386/sys/compile/JUNIPER
Timecounter "i8254"  frequency 1193182 Hz
...(many lines deleted)
FIPS self tests completed.
kern.securelevel: -1 -> 1
System watchdog timer disabled
Enter root password, or ^D to go multiuser

Note: Do not exit the shell for multiuser mode in JUNOS-FIPS. You must reboot.

Password:
Enter full pathname of shell or 'recovery' for root password recovery or RETURN for /bin/sh: 
NOTE: to go to multiuser operation, exit the single-user shell (with ^D)
NOTE:  If you exit from this shell, the system will attempt to come up normally.  However the securelevel has already been raised so kernel modules cannot be loaded and this may prevent the system being fully functional.
The best way to bring the system up from here is to 'reboot'.

Note: You must reboot JUNOS-FIPS from single-user mode to enter multiuser mode with all services intact.

Copyright © 2008, Juniper Networks, Inc. All Rights Reserved. Trademark Notice.