 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |
When a packet enters an M-series or T-series Juniper Networks router, the Physical Interface Card (PIC) receiving the packet retrieves it from the network and verifies that the link-layer information is valid. The packet is then passed to the Flexible PIC Concentrator (FPC), where the data link and network layer information is verified. In addition, the FPC is responsible for segmenting the packet into 64-byte units called J-cells. These cells are then written into packet storage memory while a notification cell is sent to the route lookup engine. The destination address listed in the notification cell is located in the forwarding table, and the next hop of the packet is written into the result cell. This result cell is queued on the appropriate outbound FPC until the outgoing interface is ready to transmit the packet. The FPC then reads the J-cells out of memory, re-forms the original packet, and sends the packet to the outgoing PIC, where it is transmitted back into the network.
Packet flow differs by platform type. This section discusses the following topics:
| Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |