VPN Operational Mode Commands

[Contents] [Prev] [Next] [Index] [Report an Error]

Table 170 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Layer 2 circuits, Layer 2 virtual private networks (VPNs), virtual private LAN service (VPLS), and Layer 3 VPNs. Commands are listed in alphabetical order.

Table 170: Layer 2 Circuit, Layer 2 VPN, and VPLS Operational Mode Commands

Task	Command
Clear MAC address entries from the VPLS table.	clear vpls mac-address
Display Layer 3 dynamic tunnel database information.	show dynamic-tunnels database
Display Layer 2 circuit information.	show l2circuit connections
Display Layer 2 VPN information.	show l2vpn connections
Display multicast VPN c-multicast route information.	show mvpn c-multicast
Display multicast VPN instance information.	show mpvn instance
Display multicast VPN neighbor information.	show mvpn neighbor
Display virtual private LAN service (VPLS) information.	show vpls connections
Display the pending events in the l2ald process rtsock update queue.	show vpls flood event-queue
Display VPLS information related to the l2ald process for the specified routing instance.	show vpls flood instance
Display VPLS route information related to the l2ald process.	show vpls flood route
Display learned VPLS MAC address information.	show vpls mac-table
Display VPLS statistics.	show vpls statistics

Note: For information about how to configure Layer 2 circuits, Layer 2 VPNs, VPLS, and Layer 3 VPNs, see the JUNOS VPNs Configuration Guide.

[Contents] [Prev] [Next] [Index] [Report an Error]