PPPoE Interface Operational Mode Commands

[Contents] [Prev] [Next] [Index] [Report an Error]

Table 63 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Point-to-Point Protocol over Ethernet (PPPoE) interfaces. Commands are listed in alphabetical order.

Table 63: PPPoE Interfaces Operational Mode Commands

Task	Command
Clear PPPoE sessions.	clear pppoe sessions
Clear PPPoE session statistics.	clear pppoe statistics
Display interface-specific information about PPPoE-configured interfaces.	show interfaces (PPPoE)
Display session-specific information about PPPoE-configured interfaces	show pppoe interfaces
Display PPPoE session statistics.	show pppoe statistics
Display PPPoE version information.	show pppoe version

Note: PPPoE interfaces are supported on Fast Ethernet and ATM-over-ADSL and ATM-over-SHDSL interfaces on the J-series routing platform. PPPoE interfaces connect multiple PPPoE-client hosts on an Ethernet LAN to a remote site through a J-series Services Router. The J-series router can only be configured as a PPPoE client. Hosts share a common digital subscriber line (DSL), a cable modem, or a wireless connection to the Internet. For information about how to configure PPPoE interfaces, see the J-series Services Router Basic LAN and WAN Access Configuration Guide or the JUNOS Network Interfaces Configuration Guide.

For information about monitoring and troubleshooting Fast Ethernet interfaces, see Ethernet Interface Operational Mode Commands.

For information about monitoring and troubleshooting ATM-over-ADSL and ATM-over-SHDSL, interfaces, see ATM Interface Operational Mode Commands.

[Contents] [Prev] [Next] [Index] [Report an Error]