Management Ethernet and Internal Ethernet Interface Operational Mode Commands

[Contents] [Prev] [Next] [Index] [Report an Error]

Management Ethernet and Internal Ethernet Interface Operational Mode Commands

Table 142 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot the management Ethernet interface and, in the case of M-series and T-series routing platforms, the internal Ethernet interface.

Table 142: Management Ethernet and Internal Ethernet Interface Operational Mode Commands

Task	Command
Monitor the M-series and T-series management Ethernet and internal Ethernet interfaces.	show interfaces (M-series and T-series Management and Internal Ethernet)
Monitor the J-series management Ethernet interface.	show interfaces (J-series Management Ethernet)

On the M-series and T-series routing platforms, the JUNOS software automatically creates the routing platform's management Ethernet interface, fxp0, which is an out-of-band management interface for connecting to the router, and the internal Ethernet interface, fxp1, which connects the Routing Engine to the Packet Forwarding Engine. If the platform has redundant Routing Engines, another internal Ethernet interface, fxp2, is created to connect the second Routing Engine (re1) to the Packet Forwarding Engine.

On the J-series routing platform, the JUNOS software automatically creates the routing platform's management Ethernet interface, fe-0/0/0, which is an out-of-band management interface for connecting to the router.

[Contents] [Prev] [Next] [Index] [Report an Error]