Setting the JCS Management Module Command Target

You can use the JCS management module CLI to direct commands to the management module or other devices installed in the JCS chassis. The device where the command takes effect is called the command target. By default, the command target is system (the JCS chassis).

• Use the env command to change the command target. For example:
  • The following command changes the command target from system to JCS management module 1 (mm[1]):
    system> env -T mm[1]

    OK
    system:mm[1]>

    The command prompt changes to system:mm[1] to indicate the command target. Unless otherwise directed, all commands you enter apply to the target shown by the prompt.

  • To return the command target to the top level of the hierarchy, type the following:
    system:mm[1]: env -T system

    OK
    system>

• Use the -T option to temporarily override the active command target for individual commands. For example, to include the following command option to redirect a command to the JCS management module in slot (bay 1), type:
  -T system:mm[1]

Table 7 lists command targets you typically use to configure and monitor the JCS 1200 platform.

Table 7: Target Paths for JCS Modules

Note: Additional target paths are available in the JCS management module CLI.

Related Topics

• Overview of JCS Management Module CLI Commands
• Logging In to the JCS Management Module CLI
• Getting Help on JCS Commands
• Exiting the JCS Management Module CLI
• env

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.