[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
Verifying Your Configuration
You can use several commands to verify that the
IPTV network is functioning and to monitor its status.
Verifying Connectivity
When you configure your IPTV network, we recommend
that you verify connectivity between routers (VSR1 and VSR2) and between
each router and certain devices using the ping command.
The format for the ping command is as
follows:
ping host source source-address
host—IP address
of the device or interface to which you want to issue the ping command.
source source-address—IP address of the outgoing interface.
To verify connectivity:
- Issue the ping command from the access interface
on each router to the loopback interface of the redundant router.
- Issue the ping command from each metro and core
interface on each router to the metro and core interface on the redundant
router.
- Issue the ping command from the loopback interface
of each router to the DHCP server.
Using Operational Commands
You can use various operational commands to obtain
information about the IPTV network and to verify that the network
is operating properly. Table 7 lists specific
operational commands that can provide information about the IPTV network
and the protocols that you configured on each video services router.
Table 7: Operational
Commands for Network Verification
|
Operational Command
|
Purpose
|
|
show dhcp relay binding
|
The expected DHCP address bindings appear in the Dynamic Host
Configuration Protocol (DHCP) client table.
|
|
show dhcp relay statistics
|
DHCP relay statistics are in line with expectations.
|
|
show igmp group
|
IGMP group membership is functioning as expected.
|
|
show igmp interface
|
- The status of each configured IGMP interface is operational
(up).
- The expected number of groups appears on each IGMP interface.
- Promiscuous mode is enabled (on) for IGMP unnumbered interfaces.
|
|
show pim interfaces
|
- The status of each PIM interface is operational (up).
- Each interface is running sparse mode.
|
|
show pim join
|
- PIM group joins are occurring as expected.
- Each join is receiving sparse mode entries.
|
|
show pim neighbors
show pim neighbors detail
|
- PIM is establishing neighbor adjacencies correctly.
- BFD is enabled.
|
|
show pim rps
|
The PIM rendezvous point router is correct.
|
|
show pim statistics
|
PIM statistics are in line with expectations.
|
For additional information about these operational
mode commands, see the JUNOS Routing Protocols and Policies
Command Reference.
Related Topics
Because the concepts that constitute logical routers
cut across the entire JUNOS software documentation set, the following
manuals can be useful references:
- For additional information about routing protocols, see
the JUNOS Routing Protocols Configuration Guide
- For additional information about interface configuration,
see the JUNOS Network Interfaces Configuration Guide
- For additional information about MPLS and related protocols,
see the JUNOS MPLS Applications Configuration
Guide
- For additional information about multicast protocols,
configuring flow maps and flow cache properties, and configuring bandwidth
management, see the JUNOS Multicast Protocols Configuration
Guide
- For additional information about operational mode commands
and output, see the JUNOS Interfaces Command Reference, the JUNOS Routing Protocols and Policies Command Reference, and the JUNOS System Basics and Services Command Reference
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
