Starting the J-Web Interface

To start the J-Web interface:

1. Launch a Web browser that has Hypertext Transfer Protocol (HTTP) or HTTP over Secure Sockets Layer (HTTPS) enabled.

   To use HTTPS, you must have installed a certificate on the routing platform and enabled HTTPS.

   Note: If the routing platform is running the worldwide version of the JUNOS software and you are using the Microsoft Internet Explorer Web browser, you must disable the Use SSL 3.0 option in the Web browser to access the routing platform.

2. After http:// or https:// in your Web browser, type the hostname or IP address of the routing platform, and press Enter.

   The J-Web login page appears.

3. On the login page, type your username and password, and click Log In.

   To correct or change the username or password you typed, click Reset, type the new entry or entries, and click Log In.

   Note: The default username is root with no password. You must change this during initial configuration or the system does not accept the configuration.

   The J-Web Quick Configuration>Set Up or Monitor>System page appears.

To explicitly terminate a J-Web session at any time, click Logout in the top pane.

Copyright © 2008, Juniper Networks, Inc. All Rights Reserved. Trademark Notice.