JUNOScope Software System Requirements

You can install the JUNOScope software on a UNIX Sun Solaris or Linux server. Ensure that the UNIX server on which you install the JUNOScope software meets the minimum system requirements. For a Sun Solaris server, see Table 7. For a Linux server, see Table 8.

Sun Solaris Server System Minimum Requirements

Before you install the JUNOScope software on a UNIX Sun Solaris server, ensure that the server meets the minimum system requirements shown in Table 7.

Table 7: JUNOScope Minimum Sun Solaris Server System Requirements

Red Hat Linux Server System Minimum Requirements

Before you install the JUNOScope software on a UNIX Linux server, ensure that the server meets the minimum system requirements shown in Table 8. (See also Red Hat Enterprise Linux ES File Package Requirements.)

Table 8: JUNOScope Minimum Linux Server System Requirements

Note: To receive system log messages from the JUNOScope software, start syslogd in Red Hat Enterprise Linux with the -r option.

Red Hat Enterprise Linux ES File Package Requirements

If a minimal install of Red Hat Enterprise Linux ES is done on the server, the JUNOScope software administrator should ensure that the file packages shown in Table 9 are installed for the JUNOScope software to run properly. Each package should be available in a full install of Red Hat Enterprise Linux ES.

Table 9: Red Hat Enterprise Linux ES File Package Requirements

To verify that the file package krb5-libs-1.3.4-17.i386.rpm is installed, use the following command:

You can install each package individually using rpm, from the original Red Hat Enterprise Linux ES distribution.

To install the file package xorg-x11-libs-6.8.2-1.EL.13.6.i386.rpm, use the following command:

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.