Tag Elements Beginning with I > <inet> (configuration/dynamic-profiles/interfaces/interface/
unit/family)

Usage

<configuration>
    <dynamic-profiles>
        <interfaces>
            <interface>
                <unit>
                    <family>
                        <inet>
                            <receive-options-packets/>
                            <receive-ttl-exceeded/>
                            <accounting>...</accounting>
                            <mac-validate>mac-validate-choice</mac-validate>
                            <rpf-check>...</rpf-check>
                            <mtu>mtu</mtu>
                            <no-redirects/>
                            <multicast-only/>
                            <primary/>
                            <ipsec-sa>ipsec-sa</ipsec-sa>
                            <demux-source>...</demux-source>
                            <demux-destination>...</demux-destination>
                            <filter>...</filter>
                            <simple-filter>...</simple-filter>
                            <policer>...</policer>
                            <sampling>...</sampling>
                            <service>...</service>
                            <next-hop-tunnel>...</next-hop-tunnel>
                            <address>...</address>
                            <unnumbered-address>...</unnumbered-address>
                            <negotiate-address/>
                        </inet>
                    </family>
                </unit>
            </interface>
        </interfaces>
    </dynamic-profiles>
</configuration>

Description

IPv4 parameters.

Contents

<accounting>—Configure interface-based accounting options.

<address>—Interface address/destination prefix.

<demux-destination>—Demux based on destination prefix.

<demux-source>—Demux based on source prefix.

<filter>—Packet filtering.

<ipsec-sa>—Name of security association.

<mac-validate>—Validate source MAC address.

• loose—Loose mac-validation.
• strict—Strict mac-validation.

<mtu>—Protocol family maximum transmission unit.

<multicast-only>—Allow only multicast traffic (tunnels only).

<negotiate-address>—Negotiate address with remote.

<next-hop-tunnel>—One or more next-hop tunnel tables.

<no-redirects>—Do not redirect traffic.

<policer>—Interface policing.

<primary>—Candidate for primary interface in system.

<receive-options-packets>—Receive IP options packets (don't send to Routing Engine).

<receive-ttl-exceeded>—Receive IP TTL-exceeded packets (don't send to Routing Engine).

<rpf-check>—Enable reverse-path-forwarding checks on this interface.

<sampling>—Interface sampling.

<service>—Service operations.

<simple-filter>—Filter for doing multifield classification.

<unnumbered-address>—Unnumbered interface address/destination prefix.