Tag Elements Beginning with I > <interface> (configuration/protocols/isis)

Usage

<configuration>
    <protocols>
        <isis>
            <interface>
                <name>name</name> <!-- identifier -->
                <disable/>
                <hello-padding-type>hello-padding-type-choice</hello-padding-type>
                <ldp-synchronization>...</ldp-synchronization>
                <lsp-interval>milliseconds</lsp-interval>
                <csnp-interval>...</csnp-interval>
                <mesh-group>...</mesh-group>
                <point-to-point/>
                <passive/>
                <checksum/>
                <no-unicast-topology/>
                <no-ipv4-multicast/>
                <no-ipv6-unicast/>
                <no-ipv6-multicast/>
                <no-adjacency-down-notification/>
                <bfd-liveness-detection>...</bfd-liveness-detection>
                <level>...</level>
            </interface>
        </isis>
    </protocols>
</configuration>

Description

Interface configuration.

Contents

<bfd-liveness-detection>—Bidirectional Forwarding Detection options.

<checksum>—Enable checksum for packets on this interface.

<csnp-interval>—Rate of CSN packets (for LAN interfaces only).

<disable>—Disable IS-IS on this interface.

<hello-padding-type>—Type of padding for hello packets.

• adaptive—Padding until state of neighbor adjacency is 'up'.
• loose—Padding until state of adjacency is 'initializing'.
• strict—Padding for all adjacency states.

<ldp-synchronization>—Advertise maximum metric until LDP is operational.

<level>—Configure levels on this interface.

<lsp-interval>—Interval between LSP transmissions.

<mesh-group>—Add the interface to a mesh group.

<name>—Interface name.

<no-adjacency-down-notification>—Do not inform other protocols about adjacency down events.

<no-ipv4-multicast>—Do not include this interface in the IPv4 multicast topology.

<no-ipv6-multicast>—Do not include this interface in the IPv6 multicast topology.

<no-ipv6-unicast>—Do not include this interface in the IPv6 unicast topology.

<no-unicast-topology>—Do not include this interface in the unicast topology.

<passive>—Do not run IS-IS, but advertise it.

<point-to-point>—Treat interface as point to point.