[Contents] [Prev] [Next] [Index] [Report an Error]

Example: Configuring Destination NAT on SRX-series Services Gateways

JUNOS software allows you to define NAT rules to translate the destination address from one IP address to another.

In this example, you perform the following tasks:

CLI Configuration

user@host# set security nat destination pool dpool-1 routing-instance ri-1
user@host# set security nat destination pool dpool-1 address 2.2.2.10
user@host# set security nat destination pool dpool-2 routing-instance ri-1
user@host# set security nat destination pool dpool-2 address 2.2.2.20
user@host# set security nat destination pool dpool-3 routing-instance ri-1
user@host# set security nat destination pool dpool-3 address 2.2.2.30
user@host# set security nat destination rule-set rs2 from routing-instance ri-1
user@host# set security nat destination rule-set rs2 rule r1 match destination-address 1.1.1.1
user@host# set security nat destination rule-set rs2 rule r1 then destination-nat pool dpool-1
user@host# set security nat destination rule-set rs3 from zone Z2
user@host# set security nat destination rule-set rs3 rule r2 match destination-address 1.1.1.1
user@host# set security nat destination rule-set rs3 rule r2 then destination-nat pool dpool–2
user@host# set security nat destination rule-set rs4 from interface fe-0/0/0.0
user@host# set security nat destination rule-set rs4 rule r3 match destination-address 1.1.1.1
user@host# set security nat destination rule-set rs4 rule r3 then destination-nat pool dpool-3
[Contents] [Prev] [Next] [Index] [Report an Error]

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.