CLI Configuration

To configure the ABC zone to allow use of all of the supported application services as inbound services, enter the following statements in Configure mode:

In the following example, FTP and telnet are enabled for interfaces ge-0/0/1.3 and ge-0/0/1. You must configure FTP and telnet at the interface level, not the zone level. For incoming FTP and telnet requests to be recognized, the interface must be known to the server.

In the following example, FTP and telnet are enabled for interface ge-0/0/1.3 and only SNMP is enabled for interface ge-0.0/1.1.

You can use the all option to allow all configurable system services and use the except option to exclude certain services. In this example, all configurable system services are permitted on interface ge-0/0/1.3, except Telnet.

In the following example, all configurable system services are permitted on interface ge-0/0/1.1, except HTTP and FTP.

In the following example, telnet and FTP are enabled for security zone ABC/interface ge-0/0/1.1, but there is an interface override that takes priority and only SNMP is allowed on interface ge-0/0/1.3.

If you are finished configuring the device, commit the configuration.

Another view of the previous configuration:

security zones 
	security-zone ABC {
		host-inbound-traffic {
			system-services {
				telnet;
				ftp;
			}
		}
		interfaces {
			ge-0/0/1.1;
			ge-0/0/1.3 {
				host-inbound-traffic {
					system-services {
							snmp;

				}
			}
		}
}

For more information on host-inbound traffic parameters, see the JUNOS Software CLI Reference.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.