 |
Note: Before configuring routing protocols on a device running JUNOS software, you must first configure security filters. For more information, see the JUNOS Software Security Configuration Guide. |
The Routing Information Protocol (RIP) is an interior gateway protocol that routes packets within a single autonomous system (AS). To use RIP, you must understand the basic components of a RIP network and configure the Juniper Networks device to act as a node in the network.
For an overview of RIPng, see RIPng Overview. For configuration instructions, see the JUNOS Routing Protocols Configuration Guide.
|
Note: Before configuring routing protocols on a device running JUNOS software, you must first configure security filters. For more information, see the JUNOS Software Security Configuration Guide. |
|
Note: In general, in this guide, the term RIP refers to RIP version 1 (RIPv1) and RIP version 2 (RIPv2). |
You can use either J-Web Quick Configuration or a configuration editor to configure a RIP network.
This chapter contains the following topics. For more information about RIP, see the JUNOS Routing Protocols Configuration Guide.
 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |