Installing a J2320 or J2350 Crypto Accelerator Module

To install a Crypto Accelerator Module:

1. Take the following steps if you have not already done so:
   1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see Preventing Electrostatic Discharge Damage.
   2. Press and release the power button to power off the Services Router. Wait for the POWER LED to turn off.
   3. Unplug the power cord or cable from the power source receptacle.
   4. Remove the chassis cover. (See Removing and Replacing the Chassis Cover on J2320 and J2350 Routers.)
2. Locate the Crypto Module connector on the system board (see Figure 83).
3. Remove the Crypto Module from its electrostatic bag.
4. Align the notches in the Crypto Module with the notches in the connector on the system board and push the Crypto Module down flat, as shown in Figure 83.

   Figure 83: Installing a J2320 or J2350 Crypto Accelerator Module

   

5. Insert the three screws and tighten them until snug. Do not overtighten.
6. Replace the chassis cover. (See Removing and Replacing the Chassis Cover on J2320 and J2350 Routers.)
7. Replace the power cord or cable.
8. Press and release the power button to power on the router. Verify that the POWER LED lights steadily.
9. Verify that the Crypto Module is correctly installed by issuing the show chassis hardware command, as shown in the following example:
   user@host> show chassis hardware

   user@host> show chassis hardware 
   Hardware inventory:
   Item             Version  Part number  Serial number     Description
   Chassis                                JN1086AA8ADA      J4350
   Midplane         REV 00   710-012339   NE0664           
   System IO        REV 00   710-012315   NE3564            JX350 System IO
   Crypto Module                                            Crypto Acceleration
   Routing Engine   REV 00   710-012149               			RE-J4350-2540
   FPC 0                                                    FPC
     PIC 0                                                  4x GE Base PIC
   Power Supply 0
   
   
   

   If Crypto Module appears in the output, the Crypto Accelerator Module is installed correctly.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.