To configure SCU, you must configure source filters and classes, apply the policy to the forwarding table, and enable accounting on inbound and outbound interfaces. This section contains configuration procedures, an SCU configuration example, and information on commands you can issue to verify your work:
 |
Note: We recommend that you stop the network traffic on an interface before you modify the DCU or SCU configuration for that interface. Modifying the DCU or SCU configuration without stopping the traffic might corrupt the DCU or SCU statistics. Before you restart the traffic after modifying the configuration, enter the clear interfaces statistics command. |
 | Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice. | |