Before You Begin

Before you begin installation, complete the following tasks:

Read the information in Maintenance and Operational Safety Guidelines and Warnings, with particular attention to Chassis Lifting Guidelines.
Determine where to install the Services Router, and verify that the rack or installation site meets the requirements described in Preparing for Router Installation.

For installation, gather the equipment and tools listed in Table 44.

Table 44: Equipment and Tools Required for Services Router Installation

Desk Installation—J2300 Services Router Only	Wall Installation—J2300 Services Router Only	Rack Installation
Rubber feet (provided)	Rubber feet (provided) Mounting brackets and screws (provided) Number 2 Phillips screwdriver Four wall screws or four mounting screws and anchors capable of supporting the full weight of the chassis, up to 12 lb (5.4 kg)	Mounting brackets and screws (provided) Number 2 Phillips screwdriver Four (J2300) or eight (J4300 and J6300) mounting screws appropriate for your rack

For installation, gather the following equipment and tools: mounting brackets and screws (provided), number 2 Phillips screwdriver, and mounting screws appropriate for your rack.
To connect the router to power and ground, have ready a grounding cable and lug, as specified in Chassis Grounding, and the power cords or cords shipped with the router. (You must supply your own power cables if you have a DC-powered router. See DC Power, Connection, and Power Cable Specifications.)

Note: The AC power cord for the Services Router is intended for use with the router only and not for any other use.
To connect network interfaces, have ready a length of cable used by the interface, as specified in Network Cable Specifications and Connector Pinouts.
If your router has ISDN ports, you might need an NT1 device to connect to the ISDN service. For details, see ISDN Provisioning.