apsConfigName
|
apsConfigEntry 1
|
A text name for the APS group.
An entry cannot exist in the active state unless all objects
in the entry have an appropriate value. Also, all associated apsChanConfigEntry rows must represent a set of consecutive channel numbers beginning
with 0 or 1, depending on the selected architecture.
|
apsConfigRowStatus
|
apsConfigEntry 2
|
The status of a APS group entry.
|
apsConfigMode
|
apsConfigEntry 3
|
The architecture of the APS group. JUNOS Software supports only
the 1+1 architecture.
|
apsConfigRevert
|
apsConfigEntry 4
|
The revertive mode of the APS group.
- Revertive mode—When the condition that caused a
switch to the protection line has been cleared, the signal is switched
back to the working line. Switching can optionally be revertive with
1+1 architecture.
- Nonrevertive mode—Traffic remains on the protection
line until another switch request is received.
|
apsConfigDirection
|
apsConfigEntry 5
|
The directional mode of the APS group. JUNOS Software supports
only bidirectional mode. Bidirectional mode provides protection in
both directions.
|
apsConfigExtraTraffic
|
apsConfigEntry 6
|
This object always returns the value disabled.
|
apsConfigSdBerThreshold
|
apsConfigEntry 7
|
The signal degrade bit error rate (BER). The negative value
of this number is used as the exponent of 10 for computing the threshold
value for the BER. For example, a value of 5 indicates a BER threshold
of 10^-5.
|
apsConfigSfBerThreshold
|
apsConfigEntry 8
|
The signal failure bit error rate. The negative value of this
number is used as the exponent of 10 for computing the threshold value
for the BER. For example, a value of 5 indicates a BER threshold of
10^-5.
|
apsConfigWaitToRestore
|
apsConfigEntry 9
|
The wait to restore period, in seconds. After a condition that
necessitated an automatic switch is cleared, the wait to restore period
must elapse before reverting. This avoids rapid switch oscillations.
GR-253-CORE specifies a range of 5 to 12 minutes. G.783 defines
a range of 5 to 12 minutes in section 5.4.1.1.3, but also allows a
shorter period in Table 2-1, WaitToRestore value (MI_WTRtime:
0..(5)..12 minutes).
|
apsConfigCreationTime
|
apsConfigEntry 10
|
The value of sysUpTime at the time the row was created.
|
apsConfigStorageType
|
apsConfigEntry 11
|
The storage type for this conceptual row. For information about
conceptual rows, see RFC 2579, Textual Conventions for SMIv2.
|
