Starting the SAE (SRC CLI)

You must configure licenses before you start the SAE. When you start the SAE, the software verifies that a valid license is available. If no license is found, the SAE does not start.

To start the SAE:

• From operational mode, enable the SAE.

  user@host> enable component sae

  Check license: OK

  Starting sae: may take a few minutes...

Related Topics

• Starting the SAE with the C-Web Interface
• Stopping the SAE (SRC CLI)
• Initially Configuring the SAE
• For information about monitoring SAE data with the SRC CLI, see Viewing Information About the Directory Blacklist with the CLI
• Obtaining an SRC License

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.