[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring System Information for the SNMP Agent (SRC CLI)

Use the following configuration statements to configure information supplied by the SNMP agent:


            
               snmp { 
               contact contact;
               
               name name;
               
               location location;
               
               description description;
               
               address [address...]; 
               
               }

To configure properties for the SNMP agent:

From configuration mode, access the configuration statement that configures the SNMP agent.
[edit] user@host# edit snmp
(Optional) Specify the administrative contact for the system being managed by SNMP.
[edit snmp] user@host# set contact contact
(Optional) Specify the name of the system being managed by SNMP.
[edit snmp] user@host# set name name
(Optional) Specify the location of the system being managed by SNMP.
[edit snmp] user@host# set location location
(Optional) Specify the description of the system being managed by SNMP.
[edit snmp] user@host# set description description
(Optional) Specify the listening address on which to receive incoming SNMP requests.
[edit snmp] user@host# set address [address...]

To list more than one IP address, enter the addresses separated by spaces within brackets. By default, the SNMP agent listens on all IPv4 interfaces.
(Optional) Verify your configuration.
```
[edit snmp] 
user@host# show 
```
If you did not configure the SNMP agent, the command displays only the SDX SNMP agent configuration.

Configuring System Information for the SNMP Agent (SRC CLI)

Related Topics