Starting the SDX SNMP Agent (C-Web Interface)

You must configure the SNMP agent and then manually start the agent. If you attempt to manually start the SNMP agent before it is configured, the software displays a message that the agent has not been configured and cannot start.

The SNMP agent automatically restarts in the event of a host reboot or process failure that stops the agent.

Before you start the SDX SNMP agent:

1. Perform the initial configuration tasks on the C Series Controller.
2. Configure the SDX SNMP agent.

   See Configuring the SDX SNMP Agent (C-Web Interface).

Manually start the SDX SNMP agent the first time it runs. Thereafter, the agent automatically restarts.

To start the SNMP agent:

1. Click Manage>Enable.
2. From the Component box, select agent.

The system responds with a start message. If the SNMP agent is already running, the system responds with a warning message indicating that fact.

Related Topics

• Starting the SDX SNMP Agent
• Stopping the SDX SNMP Agent (C-Web Interface)
• Monitoring the SDX SNMP Agent (C-Web Interface)

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.