[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring Gigabit Ethernet Interfaces for IPv6 (SRC CLI)

You can configure the Gigabit Ethernet interfaces to use IPv4 or IPv6 to allow remote access to the C-series Controller. You can specify an IP address with mask or a broadcast address with mask for an interface.

Use the following configuration statement to configure Gigabit Ethernet interfaces to use IPv6 at the [edit] hierarchy level:



interfaces name unit  unit-number  family inet6 address  address ;

To configure a Gigabit Ethernet interface to use IPv6:

From configuration mode, access the configuration statement that configures the interface.[edit] user@host# edit interfaces name unit unit-number
where unit-number is a number that you can assign for a logical interface identifier.

For example:
[edit] user@host# edit interfaces eth0
Specify the unit, family, and IP address for the interface.[edit interfaces eth0] user@host# set unit number family inet6 address address
For example:
[edit interfaces eth0] user@host# set unit 0 family inet6 address 2001:DB8:10AB:CD30::1/64

Verify the interface configuration.

[edit interfaces eth0]
user@host# show
unit 0 {
  family {
    inet6 {
      address 10AB:0:0:CD30::/20;
    }
  }
}

Configuring Gigabit Ethernet Interfaces for IPv6 (SRC CLI)

Related Topics