Starting the SRC Client on a JUNOSe Router

JUNOSe routers use an SRC client to interact with the SAE. See JUNOSe Broadband Access Configuration Guide for complete information about configuring the SRC client on a JUNOSe router.

To start the SRC client:

1. Access the router CLI.
2. Access Global configuration mode.

   host1#configure terminal

3. Switch to the virtual router for which you want to create an SRC client.

   host1(config)#virtual-router <vrName>

4. Enable the SRC client.

   To enable COPS-PR mode:

   host1:<vrName>(config)#sscc enable cops-pr

   To enable COPS-XDR mode:

   host1:<vrName>(config)#sscc enable

5. Set the primary address from the configuration directory.

   host1:<vrName>(config)#sscc primary address <ipAddress> port 3288

Related Topics

• Stopping the SRC Client on a JUNOSe Router
• Accessing the Router CLI
• Specifying Router Initialization Scripts on the SAE with the CLI
• Viewing Statistics for All JUNOSe Device Drivers (SRC CLI)

Copyright © 2009, Juniper Networks, Inc. All rights reserved. Trademark Notice.