[Contents] [Prev] [Next] [Index] [Report an Error]

Configuring Gigabit Ethernet Interfaces for IPv4 (SRC CLI)

You can configure the Gigabit Ethernet interfaces to use IPv4 or IPv6 to allow remote access to the C-series Controller. You can specify an IP address with mask or a broadcast address with mask for an interface.

Use the following configuration statements to configure Gigabit Ethernet interfaces to use IP v4 and the [edit] hierarchy level:



interfaces name unit  unit-number  

interfaces name unit  unit-number  family inet {
address  address ; 
broadcast  broadcast ; 
}

To configure a Gigabit Ethernet interface to use IPv4:

From configuration mode, access the configuration statement that configures the interface.
where unit-number is a number that you can assign for a logical interface identifier.

For example:
Specify the unit, family, and IP address for the interface.
For example, to configure an interface with only an IP address:

Verify the interface configuration.

[edit interfaces eth0]
user@host# show
unit 0 {
  family { 
    inet6 { 
      address 192.2.0.10/24;
    }
  }
}

[Contents] [Prev] [Next] [Index] [Report an Error]