Configuring Gigabit Ethernet Interfaces for IPv4 (SRC CLI)

You can configure the Gigabit Ethernet interfaces to use IPv4 or IPv6 to allow remote access to the C-series Controller. You can specify an IP address with mask or a broadcast address with mask for an interface.

Use the following configuration statements to configure Gigabit Ethernet interfaces to use IP v4 and the [edit] hierarchy level:

interfaces name unit unit-number
interfaces name unit unit-number family inet {
address address ;
broadcast broadcast ;
}

To configure a Gigabit Ethernet interface to use IPv4:

  1. From configuration mode, access the configuration statement that configures the interface.
      [edit]
      user@host# edit interfaces name unit unit-number

    where unit-number is a number that you can assign for a logical interface identifier.

    For example:

      [edit]
      user@host# edit interfaces eth0
  2. Specify the unit, family, and IP address for the interface.
      [edit interfaces eth0]
      user@host# set unit number family inet address address

    For example, to configure an interface with only an IP address:

      [edit interfaces eth0]
      user@host# set unit 0 family inet6 address 192.2.0.10/24
  3. Verify the interface configuration. 
    [edit interfaces eth0]
user@host# show
unit 0 {
  family {
    inet6 {
      address 192.2.0.10/24;
    }
  }
}
    

    4.