[Contents] [Prev] [Next] [Index] [Report an Error]

Creating a One-Rate Rate-Limit Profile

To create or modify a one-rate rate-limit profile, use the following commands with the one-rate keyword:

ip rate-limit-profile command
ipv6 rate-limit-profile command
l2tp rate-limit-profile command
mpls rate-limit-profile command

The following example creates a rate-limit profile named tcpFriendly8Mb. This rate-limit profile, when included as part of a rule in a policy list, sets a TCP-friendly rate for a specified flow:



host1(config)#ip rate-limit-profile tcpFriendly8Mb
one-rate 

host1(config-rate-limit-profile)#committed-rate
8000000 

host1(config-rate-limit-profile)#committed-burst
1500000 

host1(config-rate-limit-profile)#excess-burst
3000000 

host1(config-rate-limit-profile)#committed-action
transmit 

host1(config-rate-limit-profile)#conformed-action
transmit 

host1(config-rate-limit-profile)#exceeded-action
drop 

host1(config-rate-limit-profile)#mask-val
255

To configure a single-rate hard limit, set the committed rate and burst rate to the desired values, the committed action to transmit, the conformed action to drop, and the exceeded action to drop. The peak rate must be set to zero.

Note: You can also achieve the characteristics of the single-rate hard limit by configuring a one-rate rate-limit profile with the extended burst rate set to zero.

Creating a One-Rate Rate-Limit Profile

Related Topics