Before You Configure PPP

Before you configure a PPP interface, configure the interface or tunnel over which PPP traffic will flow. See the following chapters:

• Configuring Channelized T3 Interfaces in JUNOSe Physical Layer Configuration Guide
• Configuring T3 and E3 Interfaces in JUNOSe Physical Layer Configuration Guide
• Configuring Unchannelized OCx/STMx Interfaces in JUNOSe Physical Layer Configuration Guide
• Managing Tunnel-Service and IPSec-Service Interfaces in JUNOSe Physical Layer Configuration Guide
•  Configuring ATM
•  Configuring Packet over SONET
•  Configuring Point-to-Point Protocol over Ethernet

The procedures described in this chapter assume that a physical interface has been configured.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.