[Contents] [Prev] [Next] [Index] [Report an Error]

Before You Configure IPv6

Before you configure IPv6, you must create the lower-layer interfaces over which IPv6 traffic flows. In this release, the following modules support IPv6 configuration:

ATM OC3/STM-1
ATM OC12/STM-4
Fast Ethernet (FE-8)
Gigabit Ethernet (GE)
10-Gigabit Ethernet (10GE)
OC48 POS (PPP only)

For example, to configure an ATM interface:



host1(config)#interface atm 1/0 

host1(config-if)#atm sonet stm-1 

host1(config-if)#no loopback 

host1(config-if)#atm clock internal chassis 

host1(config-if)#interface atm 1/0.10 

host1(config-if)#atm pvc 10 0 20 aal5snap

See Configuring ATM in the JUNOSe Link Layer Configuration Guide for information about configuring an ATM interface. See Configuring Ethernet Interfaces in the JUNOSe Physical Layer Configuration Guide for information about configuring an Ethernet interface.

[Contents] [Prev] [Next] [Index] [Report an Error]