Monitoring Bridging-Related Settings for VPLS

You can use the show commands listed in Table 82 to display VPLS settings related to transparent bridging. Except for the show bridge interface vpls command, which is only for VPLS instances, you can use these commands to monitor both VPLS instances and standard bridge groups for transparent bridging.

Table 82: Commands for Monitoring VPLS Bridging Settings

Related Topics

•  Monitoring VPLS Configuration and Statistics for a Specific VPLS Instance
•  Monitoring VPLS Configuration and Statistics for all VPLS Instances
•  Monitoring Configuration, Statistics, and Status for VPLS Network Interfaces
•  Monitoring Configuration, Statistics, and Status for VPLS Core Interfaces
•  Monitoring Configuration, Statistics, and Status for VPLS Ports
•  Monitoring MAC Address Entries for a Specific VPLS Instance
•  Monitoring Subscriber Policy Rules
• For more information about using these commands, see Monitoring Transparent Bridging in the JUNOSe Link Layer Configuration Guide.

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.