[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
Layer 2 Services over MPLS References
For information about layer 2 services, consult
the following resources:
- Encapsulation Methods for Transport of ATM Over MPLS
Networks—draft-ietf-pwe3-atm-encap-07.txt (April 2005 expiration)
- Encapsulation Methods for Transport of Ethernet Frames
Over IP/MPLS Networks—draft-ietf-pwe3-ethernet-encap-05.txt
(June 2004 expiration)
- Encapsulation Methods for Transport of Layer 2 Frames
Over IP and MPLS Networks—draft-martini-l2circuit-encap-mpls-08.txt
(March 2005 expiration)
- Encapsulation Methods for Transport of PPP/HDLC Over
IP and MPLS Networks—draft-ietf-pwe3-hdlc-ppp-encap-mpls-03.txt
(October 2004 expiration)
- Framework for Pseudo Wire Emulation Edge-to-Edge (PWE3)—draft-ietf-pwe3-arch-06.txt
(April 2004 expiration)
- IEEE 802.3ad (Link Aggregation)
- Pseudowire Setup and Maintenance Using LDP—draft-ietf-pwe3-control-protocol-08.txt
(January 2005 expiration)
- Requirements for Pseudo-Wire Emulation Edge-to-Edge (PWE3)—draft-ietf-pwe3-requirements-08.txt
(June 2004 expiration)
- Transport of Layer 2 Frames Over MPLS—draft-martini-12circuit-trans-mpls-11.txt
(October 2003 expiration)
 |
Note:
IETF drafts are valid for only 6 months from the date of issuance.
They must be considered as works in progress. Please refer to the
IETF Web site at http://www.ietf.org for the latest drafts.
|
For information about configuring supported layer
2 interfaces, consult the following resources:
- JUNOSe Physical Layer Configuration Guide
- See Configuring ATM in JUNOSe Link Layer Configuration Guide.
- See Configuring Frame Relay in JUNOSe Link Layer Configuration Guide.
- See Configuring Packet over SONET in JUNOSe Link Layer Configuration Guide.
- See Configuring Bridged Ethernet in JUNOSe Link Layer Configuration Guide.
For information about configuring supported serial
interfaces, which are also referred to as HDLC channels, see the following
resources:
- See Configuring Channelized T3 Interfaces in JUNOSe Physical Layer Configuration Guide.
- See Configuring T3 and E3 in JUNOSe Physical Layer Configuration Guide.
- See Configuring Channelized OCx/STMx Interfaces in JUNOSe Physical Layer Configuration Guide.
For information about configuring MPLS, see Configuring MPLS.
[Contents]
[Prev]
[Next]
[Index]
[Report an Error]
