Configuring Ethernet/VLAN Layer 2 Services

To configure Ethernet/VLAN layer 2 services over MPLS:

1. Configure the Ethernet/VLAN interface.

   host1(config)#interface fastEthernet 4/0

   host1(config-if)#encapsulation vlan

   host1(config-if)#interface fastEthernet 4/0.3

   host1(confi-if)#vlan id 201

2. Specify MPLS tunneling by using the appropriate command.

   host1(config-if)#mpls-relay 10.10.100.2 45

   or

   host1(config-if)#route interface tunnel mpls:tunnel6 45

3. Configure Ethernet/VLAN and MPLS on the remote PE router.

Related Topics

• encapsulation vlan command
• interface fastEthernet command
• mpls-relay command
• route interface command
• vlan id command

Copyright © 2008, Juniper Networks, Inc. All rights reserved. Trademark Notice.